> For the complete documentation index, see [llms.txt](https://docs.timeinpixels.com/llms.txt). Markdown versions of documentation pages are available by appending `.md` to page URLs; this page is available as [Markdown](https://docs.timeinpixels.com/nobe-omniscope/sources/aja.md).

# AJA

Nobe OmniScope supports any AJA SDI or HDMI input card (both PCIe and Thunderbolt). It will be detected automatically and displayed in the “Connect to…” dialog box.

### Input and pixel format

Choose the connector under **Input Source** and the capture format under **Pixel Format** in the AJA input settings. The available formats depend on the connected AJA card.

In **1.11.68 beta** and later, the pixel-format list includes **RGB-10** on compatible hardware. This also supports 10-bit RGB in square-division quad-link SDI workflows. Enable **QuadLink UHD** for a four-link source, then follow the [UHD Quad Link setup](https://docs.timeinpixels.com/nobe-omniscope/sources/aja/uhd-quad-link-config-for-aja-kona-4.md) and confirm that all four links use the same format.

### REC Badge

Supported AJA SDI sources can show a **REC** badge in the Source Viewer when embedded frame-status metadata reports that the camera is actively recording. This gives you a quick visual confirmation without opening additional diagnostics.

### Expected input range (diagnostic builds)

The NOS-2924 v4 diagnostic build adds **Expected input range** to the AJA input settings:

* **Auto** uses the input range metadata. If none is available, it assumes Video for YCbCr and Full for RGB.
* **Video** interprets the incoming signal as video/legal range.
* **Full** interprets the incoming signal as full/data range.

Match this setting to the signal sent by the source, then click **Restart Capture**. The selection is saved for that input. When AJA converts between RGB and YCbCr, OmniScope also configures that conversion for the selected input range.

To display the scopes in full range, separately enable **Scale the video/SDI range to the full range** under **Input Settings → Settings → Scale & range**. **Show legal range** only controls the legal-limit guides.
